Voted Best Answer
Jan 16, 2023 - 07:48 PM
Very slightly loosen the allen head 2 screws on both sides of the centre hex nut. (These should be 3mm allex screws.)
Take your digital angle cube, zero it on the table your Hapstone is standing on (zero the angle cube parallel with the clamp bar). Now place the angle cube on one side of the clamp bar, then the other side. Compare both sides and adjust it up or down until they are exactly the same. Now carefully tighten both 3mm allen head screws again, making sure not to mis-align the clamp bar again while tightening.
Hope this helps!
Take your digital angle cube, zero it on the table your Hapstone is standing on (zero the angle cube parallel with the clamp bar). Now place the angle cube on one side of the clamp bar, then the other side. Compare both sides and adjust it up or down until they are exactly the same. Now carefully tighten both 3mm allen head screws again, making sure not to mis-align the clamp bar again while tightening.
Hope this helps!
Add New Comment