Guided sharpening systems Q&A
SubscribeActivity timeframe



What is the size of the single clamp screws used to hold the blade?
Asked 1 year ago 1 answer

What guided system has a full flat grind clamps like KME?
Asked 2 years ago 1 answer

Will the Kazak Scissor Holder Fit on a Hapstone K1 with Slot Opening of 8mm?
Asked 2 years ago 1 answer

will these Central Y-Shaped Clamp for Hapstone R2 work with the Hapstone R2 Opti Knife Sharpener
Asked 2 years ago 1 answer


What is the best sharpening system without compromise?
Asked 1 year ago 1 answer


Will the TSPROF clamps fit the toohr 3 knife sharpener?
Asked 3 months ago 1 answer

Will this part replace the stationary stop on my K03 Pro Hunter (opposite the axicube)?
Asked 3 months ago 1 answer

Does this holder have metal bushings (e.g. brass)?
Asked 3 months ago 1 answer
6" Stone Holder for Work Sharp Professional Precision Adjust

How to ID TSPROF Center Fillet va TSPROF standard center clamp?
Asked 4 months ago 1 answer

Slight Angle Difference with the Axicube From One Side To The Other
Asked 4 months ago 1 answer

Will this work with the Hapstone R2?
Asked 4 months ago 1 answer

TSPROF pioneer extra clamps and clamp frame.
Asked 7 months ago 1 answer

What is the difference between kadet pro and kadet pro "t"? Is anodized finish the only difference?
Asked 7 months ago 1 answer




Is the Hapstone scissor Attachment the updated version or old version?
Asked 11 months ago 1 answer


Asked 1 year ago 1 answer
Guided sharpening systems > Hapstone, Guided sharpening systems > TSPROF

Asked 1 year ago 1 answer


Are Hapstone clamps compatible with the Kazak Poland Model 100?
Asked 1 year ago 1 answer

Will other Hapstone clamps work on the "Hapstone Planeshift Clamps Upgrade for KME?
Asked 1 year ago 1 answer

what happend to the freehand assist T1
Asked 1 year ago 1 answer

Will the 3d printed Leading Edge sharpener be sold as a kit or fully assembled and when?
Asked 1 year ago 1 answer


Starting from zero. Need to sharpen EDC knives (small folders) and kitchen knifes.
Asked 2 years ago 1 answer

What size rod does the linear ball bearing pivot for Hapstone accecpt?
Asked 2 years ago 1 answer

Why are my Hapstone R2 Standard Knife Sharpener clamp screws stuck? I cannot clamp down my knife.
Asked 2 years ago 1 answer


Are your 3D printed designs available as CAD or mesh models?
Asked 2 years ago 1 answer

When will your kits be back in stock?
Asked 2 years ago 1 answer







Asked 2 years ago 1 answer