Answers
Jan 03, 2024 - 03:02 AM
Yes. As long as your venev dual sided stones are the 4 inch and not the 6 inch. Just be careful not to torque down the tightening knob too much on the 3D printed stone holder. Just snug it up until the stone doesn't easily move or you'll eventually crack one of the ends of the holder and have to gorilla glue it like I did. Leading Edge recommends using a small piece of duct type tape on the ends of your square ended stones to make them grip better and that helps.
Jan 03, 2024 - 08:44 AM
Yes, it will work well with 4 inch dual sided Venev stones.
Add New Comment