I have a K02 with the old style clamping arm. is it possible to get just the K03 clamping arm?
Экспертный корпус с расширенным углом для TSProf K03
If the center hole size is the difference I could always bore it out or put in a bushing to make it the right size. If not, is it possible to buy a K03 frame without the lifter? I already have the K03 lifter mechanism. I have a lot of money invested in my K02 and I don't want to but a whole new setup so I can use the new style clamps I need.
Question ID: 5426601 Status:
Open Dec 14, 2024 - 09:49 AM
2answers
Answers
Dec 14, 2024 - 02:33 PM
The K03 stone arm rod is 8mm in diameter. I do not have a K02 at hand to measure the rod diameter but I am fairly certain it's the same. Measure your K02 rod diameter, if it is 8mm, then the K03 stone clamp guide rod will work just fine.
Dec 14, 2024 - 03:53 PM
I think I did not make myself clear. That is not the part I need. I need the arm with the slot in it the the clamps that hold the knife connect to. The old style went inside the slot. The new style clamp is U shaped and fits around the edge of the arm.
Answer this question
View More Product Details
Экспертный корпус с расширенным углом для TSProf K03
Примечание для международных покупателей: Многие страны, включая Канаду и Австралию, ввели высокие тарифы на импорт товаров из России. В связи с этим мы приостановили международные поставки для TSPROF заточных систем. Корпус K03 с расширенным углом включает в себя основные компоненты точилок для нож...
See More
View Details
View all Экспертный корпус с расширенным углом для TSProf K03 Questions & Answers
Share Your Own Experience & Expertise
We look to ensure that every question is answered by the best people with relevant expertise and experience, the best answers include multiple perspectives. Do you have relevant expertise or experience to contribute your answer to any of these commonly asked questions?
Add New Comment